Key Defect Evidence Photos
Short Edges & Incomplete Coverage
Film cut excessively short along edges, leaving visible gaps and unprotected borders.
Large Imperfection in Windshield
Significant optical distortion and physical imperfection permanently trapped inside windshield tint.
Nail Polish / Marker on Short Edge
Attempted cover-up of miscut short edge using black marker or nail polish along the seam.
Marker Filling Short Corner
Marker applied directly onto the corner to disguise severe shrinkage and missing film.
Overstretching and Film Failure
Excessive heat and tension during installation caused structural breakdown and film distortion.
Short and Jagged Cut Edge
Rough, uneven razor trimming resulting in jagged exposed borders and poor seam alignment.
Not Fully Wrapped - Bottom Failure
Bottom edge was never properly wrapped around body line, causing immediate premature peeling.
Poor Install and Edge Peeling
Film curling and separating from the vehicle surface due to improper bonding and install technique.
Razor Cut Into Film
Deep razor cuts scoring through film surface caused by careless hand-trimming.
Peeling Edge Separation
Persistent perimeter detachment where adhesive completely failed to hold.
Dirt Trapped Under Film
Heavy dirt, dust, and particle contamination sealed beneath the tinted layer.
Bubbles and Dirt Over 1 Month Later
Permanent air pockets and trapped contamination still plainly visible weeks after curing period.
Additional Vehicle Inspection Photos
Not Protected
Critical edges and surfaces were left exposed, leaving the vehicle vulnerable to damage and wear.
Poor Edge Coverage
The tint does not extend fully to the edge, leaving visible gaps.
Surface Damage
Scratches and marks are visible due to improper handling during installation.
Crease in Tint
Permanent creases have formed, affecting both the appearance and performance of the tint.
Uneven Trim Line
The film has been cut unevenly, resulting in an unprofessional finish.
Incomplete Coverage
The tint fails to cover the entire glass area, exposing visible sections.
Misaligned Installation
The film is not properly aligned, leaving inconsistent edges.
Improper Edge Finish
Rough trimming and poor finishing are visible around the edges.
Tint Failure
The film is lifting and separating, indicating an installation failure.
Stops Short of Full Coverage
The tint does not reach the intended edge, leaving noticeable gaps.
Dust Contamination
Dust particles have been trapped beneath the film during installation.
Visible Installation Marks
Surface imperfections remain clearly visible after installation.
Air Bubble Formation
Trapped air has created bubbles beneath the film.
Contaminants Under Film
Dirt and debris are sealed under the tint, reducing clarity.
Edge Peeling
The film has started peeling away from the edge prematurely.
Visible Haze
Poor installation has resulted in a cloudy or hazy appearance.
Misaligned Lower Edge
The bottom edge has been trimmed unevenly and lacks proper alignment.
Surface Scratches
Installation has left visible scratches on the tinted surface.
Foreign Particles
Small particles are trapped beneath the tint, creating visible imperfections.
Mirror Area Peeling
The tint around the mirror area is peeling and separating.
Adhesive Failure
The adhesive has failed, causing lifting and poor bonding.
Star Crease in Tint
A star-shaped crease has formed, permanently damaging the film.
Pressure Marks
Excessive pressure during installation has left visible marks on the film.
Improper Edge Sealing
The edges are not properly sealed, increasing the risk of peeling.
Tiny Bubble Formation
Small bubbles remain trapped beneath the tint.
Hairline Scratch
Fine scratches are visible, affecting the finish of the installation.
Chip or Nick in Film
The tint has suffered a small chip due to poor handling.
Uneven Side Edge
The side edge lacks a straight, clean finish.
Poor Corner Finish
Corners have not been properly trimmed, leaving excess material.
Lifted Corner
The corner of the tint has started lifting, reducing durability.
Gap Along Window Frame
Visible spacing exists between the tint and the window frame.
Final Edge Defect
The edge finish remains inconsistent, showing signs of poor craftsmanship.
Defect Inspection #33
Detail view of service inspection.
Defect Inspection #34
Detail view of service inspection.
Defect Inspection #35
Detail view of service inspection.
Defect Inspection #36
Detail view of service inspection.
Defect Inspection #37
Detail view of service inspection.